|
ascMcLaren Enthusiasts An asc McLaren forum for ALL Mustang and Capri based cars modified by Automotive Speciality Corporation, a Division of American Sunroof Corporation. (a trademarked corporation) with no affilation to this site.
|
View previous topic :: View next topic |
Author |
Message |
86MclarenCapri
Joined: 27 Sep 2015 Posts: 231 Location: Norfolk, VA
|
Posted: Thu Oct 20, 2016 1:33 pm Post subject: My 86 is acting up again |
|
|
So, I have a mobile auto electric guy coming over today to figure out what my electrical issue is. When I start the car and immediately put it in gear, it stalls and then won't start. I have to wait at least a day to get it to start again. If I let it warm up for 5 minutes or so, I don't get that problem.
Sounds like a short somewhere. I'll update later. _________________ Dan
Norfolk, VA
86 Capri Convt Silver/Charcoal/Black
67 Mustang GTA Convt |
|
Back to top |
|
|
capri50asc
Joined: 26 Dec 2009 Posts: 290 Location: Canton Michigan
|
Posted: Thu Oct 20, 2016 6:00 pm Post subject: Starting/Stalling Cutting out problems |
|
|
Dan
Change the Dist Ignition control Module. These break down from the heat off the distributor and if the dielectric grease is not used as a heat barrier , it will fail faster. Also when you shut the car down. The fan and coolant stop moving and the under hood temps, can climb to over 400 degrees, This bakes the module. I open the hood on my two cars to let the heat escape . When this fails it can cause all kind of problems. Stalling, No starts, missing etc (Use Motorcraft only!)
2) Change the Ignition Switch in the steering column (between the key and the dash) Pull the covering off, Two screws and two connectors . Use small vise grips to remove the two screws then replace them with ones from NPD part number is M-11572-1k When these go everything in the car will act up, Stalling on turns, No starts, Cruise control will fail, no lights , radio etc etc etc . The grease inside them drys out, which in turn causes metal to metal contact on the sliding unit. use Motorcraft or Standard . Both Good!
Chris |
|
Back to top |
|
|
negusm Site Admin
Joined: 25 Aug 2004 Posts: 5183 Location: Charlotte, NC
|
Posted: Thu Oct 20, 2016 6:08 pm Post subject: |
|
|
On the ignition parts: ONLY USE FORD/MOTORCRAFT!
-Mike _________________ 1985 ascMcLaren Coupe - Midnight Blue
Under Restoration |
|
Back to top |
|
|
86MclarenCapri
Joined: 27 Sep 2015 Posts: 231 Location: Norfolk, VA
|
Posted: Fri Oct 21, 2016 4:17 am Post subject: |
|
|
Chris-- I took your advice and replaced everything on your list!!
It turned out that the distributor pickup was bad? And, that was the second rebuilt distributor!!
And, Mike, Your're right, Rebuilt twice?? And I replaced the ICM TWICE!! _________________ Dan
Norfolk, VA
86 Capri Convt Silver/Charcoal/Black
67 Mustang GTA Convt |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|