2593
<<
Message Index
>>
2595 Number: 2594 From: "Sandy Block" <cigarsandy@c...> Date: Fri May 9, 2003 2:48 am Subject: Re: Ready? E N G I N E !!!!!!!!!!
Body:
Sorry, I left it off. According to the paper, all done by FORD under D32 code.
--- In ascmclaren@yahoogroups.com, "negusm" <negusm@y...> wrote: > Were these changes all done by ascMcLaren or by Ford, or doesn't it > say? > > -Mike > >
--- In ascmclaren@yahoogroups.com, "Sandy Block" <cigarsandy@c...> > wrote: > > I have a little UNexpected time this AM,so lets go tackle the > final > > section: ENGINE. > > > > * Replace Rocker Arms to Increase Usabe Rev Limit to 7000 RPM. > > (Power Gain of 5%). > > * Upgrade Exhaust Header (Stainless Steel) Internal Mandrel Bent > to > > include Exhaust Port Liners to be tuned with lower restriction > > exhaust. > > * Tuned Muffler to Reduce Back-Pressure & Enhance Exhaust Note. > > * Prototype Valve Springs & Prototype Valve Guides > > * B-303 Ford Motorsport Hi Po Cam > > > > Now, before you hop all over ME, keep in mind that I am just > copying > > from ascMcLaren Internal "FINAL MEMO" Pre-Job1 Program. Again, > this > > was to apply ONLY to 1985/1986 Full Packaged Coupes, which covers > 150 > > 1985s & 115 1986s, for a grand total of 265 cars. > > > > S A N D Y (adorning a Hard Hat !!)